Mobile Gas & Propane

For International clients 1 KCal = 3.968 BTU

The MB Range Mobile Oil-Fired Air Heaters. Heat Where it is needed.

Available in a full range of four handy and soildly constructed models, they have numerous virtues which are translated into concrete advantages for the user. The MB range oil heaters represent an effective answer to the increasing demend for autonomous and independent mobile air heaters.

Total safety and reliability

Designed and constructed following the strict ISO 9002 procedures.

Clean air, always and everywhere

The exhaust circuit is completely isolated from the warm air flow.

Direct heat exchange: goodbye to freezing

The heating takes place without an intermediate fluids (water, vapour) definitively resolving the problem of freezing.

Mobil Cikki 70 Moving Performances

Mobil Cikki 70 Direct or ducted air difusion. Inside or outside installation.

Heating Capacity Output	kW	76,1⁽¹⁾
	kcal/h	65.480⁽¹⁾
	kW	70,0
	kcal/h	60.200⁽²⁾
Air Flow	m³/h	2.000
Temperature Deviation	°K	130
Air Throw	m.	30
Electrical Protection Degree	IP	44
Elettrical Supply	Phase+Neutral+Earth	230V ~ 50Hz
Fan's Electric Power	kW	0,300
Max Power Fan Motor	A	3,0
Type		A₂
LPG Cyclinder Capacity		N°2 x 25 kg
Fuel Propan Gas (G31)
- Gas pressure	mBar	37-50
- Consumption ⁽³⁾	kg/h	5,44
- Autonomy	h.	9/10
Fuel Butan Gas(G30)
- Gas pressure	mBar	30-50
- Consumption ⁽⁴⁾	kg/h	5,52
- Autonomy	h.	9-10
(1) P.C.S. = 24.322 kcal/nm³ (2) P.C.I. = 22.360 kcal/nm³ (3) atmospheric pressure 1013 mbar gas temperature 15° c- P.C.I. 11070 kcal/kg. (4)almospheric pressure 1013 mbar gas temperature 15°c - P.C.I. 10950 kcal/kg.

Casing Dimensions

DGS Range Mobile Oil Burning Air Heaters

Typical Oil Mobile Heaters. Also available in propane.

Particularly suitable for heating open air working areas - for accelerated drying of plaster, flooring, upholstery, damp rooms to be reclaimed, -for drying paint, precompressormaterial, timber, - to defrost tubes and material in general, - to preheat motors, machinery and in all those circumstances when emergency heating is required.

The special characteristic of the DGK range warm air heaters is the direct mixing of combustion by-products with the air used, ensuring thermal efficiency of 100% and not necessitating flue.

In the DGS version a heat exchanger separates the combustion gases from the warm air, which is thus absolutely clean and hygienic. Solid and compact, the DGK-DGS range of warm air heaters consist essentially of the following components, which may be completely disassembled:

Combustion chamber in stainless steel with burner nozzle and combustion air adjustment shutter
Heat exchanger (DGS only) in coiled stainless steel, with chimney attachment.
Typical Portable Gas/Propane Unit

External cylindrical casing, stove-enamelled with inspection door giving access to internal parts.
Heating oil storage tank, large capacity.
Large diameter rubber-tyred wheels with support and handle for manoeuvring the equipment.
Axial-flow fan with monophase electric motor and accident protection guard.
Oil-fired burner unit, complete with nozzle, electrodes, pump and gearing, electrovalve and ignition transformer.
Electrical equipment for control and safety of the completely automatic operation system, including cyclical programmer, light-resistance, thermostatic capsule for automatic fan control, operation switch
and plug for possible connection of room thermostat.

GC Mobile Air heater

Introduction

GC Mobile Air Heater is designed for a wide range of indoor environments, including poultry houses, greenhouses, commercial and industrial premises. The heater works on the principle of indirect combustion with heat exchanger, which ensures clean operation and prevents any emission of exhaust gas into the house.

The GC heater can burn wide range of fuels such as diesel, natural gas, LPG or propane (paraffin upon request). It is supplied fully assembled and ready for installation. The standard product line encompasses a wide range of sizes with nominal heating efficiencies around 90 %.

Technology basis

The GC Air Heater works on a principle of indirect combustion with heat exchanger, where the flue gases and the air stream are completely separated. The exhaust gases are ventilated outside the building through the chimney.

The heart of the heater is the combustion chamber and the heat exchanger. A powerful centrifugal fan forces room air at high pressure into the heat exchanger where the air absorbs heat from the flue gases. The warm and dry air is then supplied into the room through the air outlets. The air outlets are equipped with air deflectors for optimal distribution of the warm air to the points where it is needed most.

GC Equipment

High efficiency
Protected against corrosion (housing is made from pre-coated galvanized steel, combustion chamber and heat exchanger are made from stainless steel)
Ready to install
Prevention of faulty operation (a dual switching safety thermostat controls the fan motor and the burner)
Easy to inspect the burning process
Easy to operate Different air diffusers are available on request
Suitable for diesel, natural gas, LPG or propane (paraffin upon request)

Index Page | Heating Systems | Heating Systems & Technology
Hieating Systems for All Types | Natural Gas/Propane
Oil Heat | Boilers | Mobile Gas/Propane | Mobile Oil | Waste Oil
Cikki Animal/Poultry | In/under Bench

Mobile Gas & Propane For International clients 1 KCal = 3.968 BTU